HR-30 INK DEGRADENT / MILD STAIN REMOVER
HR-30 is a water soluble screen wash designed for the removal of all inks, including plastisol and UV inks. HR-30 works especially well on tough inks such as water base, vinyl epoxy and enamels. HR-30 can also be used for the removal of stubborn cured ink stains (ghost or haze).
MANUALLY: Card excessive ink from the screen. Spray or apply manually to the ink side of the screen. Agitate both sides of the screen with a non-abrasive brush or pad and allow product to penetrate. Starting at the bottom of the screen, rinse off all reisdue with high pressure water.
RECIRCULATING: Card excessive ink from the screen. HR-30 can be continuously re-circulated until product becomes too heavily soiled with solids. Used product may be filtered and reused.
CURED INK REMOVER (STAIN): Remove the ink and emulsion from the screen. Spray or apply manually to both sides of the screen. Scrub both sides of the screen with non-abrasive brush or pad. Allow product to remain on the screen for a minimum of 3 minutes. Starting at the bottom of the screen, high pressure water rinse both sides of the screen. *Dispose of in accordance with state, local and federal regulations. Check with your local sanitation district regarding limitations on inks that are to be rinsed into the drain.
AVAILABLE PACK SIZES:
1 GAL. | 5 GAL. | 30 GAL. (DRUM) | 55 GAL. (DRUM)